Page 1 of 1

3D Interpolation

Posted: Fri Jun 09, 2006 2:28 pm
by bagory

I would like to know if there is an AIMS (or a BrainVisa process) which permit to linearly interpolate a 3D Volume in the 3 directions ? E. g. to transform a 32x32x1 image into a 256x256x10 image with the same FOV.

Thanks in advance for your help.


Posted: Fri Jun 09, 2006 3:12 pm
by riviere

Try the Resampling process in BV (in Toolbox), or the AimsResample commandline.


Re: 3D Interpolation

Posted: Tue Aug 25, 2009 4:50 am
by jackthomas
I would like to do an interpolation in 3D. I looked in nr book and found the following comment in chapter 3.6. : "we will not here consider the problem of interpolating on a mesh that is not cartesian"...
And of course , I would like to interpolate my values on a not cartesian grid... In fact, I have a varying number of interpolation points that are placed "randomly"...
Where could I find an algorithm or a method that I could apply to my case ?
Thank you
Reply With Quote