Holes in white matter mesh
Posted: Wed Jul 25, 2018 4:57 pm
Hello,
this post is just to point out something I noticed while importing unusual data, i.e. chimpanzee data that have been segmented with a different software.
I imported segmentations into BV, ran the missing step, etc... Then I ran the topological corrections, then the grey/white mesh extraction. I got a number of holes in the surface. On the other hand when I replace this last step by the process 'white mesh without decimation' I do not get them. The only difference between the two methods are the parameters of 'AimsMeshBrain'. So this process can generate holes in a spherical surfaces I guess. I thought it would be worthwhile pointing out. Below is an image pointing out the holes (red arrows). In green is the result of 'WM without decimation', in grey is the standard Morphologist mesh, with holes.
Olivier
this post is just to point out something I noticed while importing unusual data, i.e. chimpanzee data that have been segmented with a different software.
I imported segmentations into BV, ran the missing step, etc... Then I ran the topological corrections, then the grey/white mesh extraction. I got a number of holes in the surface. On the other hand when I replace this last step by the process 'white mesh without decimation' I do not get them. The only difference between the two methods are the parameters of 'AimsMeshBrain'. So this process can generate holes in a spherical surfaces I guess. I thought it would be worthwhile pointing out. Below is an image pointing out the holes (red arrows). In green is the result of 'WM without decimation', in grey is the standard Morphologist mesh, with holes.
Olivier