Backface culling in Anatomist when viewing a mesh

HughTG · Post by **HughTG** » Tue Jun 01, 2004 3:28 pm

When using Anatomist 1.30, and I display a mesh with clipping planes active, the software appears to have backface culling active. Is there a user option / ini file flag to turn backface culling on or off?

Hugh Griffiths

Post by **riviere** » Tue Jun 01, 2004 4:10 pm

Hi Hugh,

You can turn off backface culling in the tools window (the same as the one you used to turn on plane clipping), but what is not enabled is two-side lighting, so the inside face of a mesh appears black (which is not very useful I admit). I will think about enabling it too...

Denis

Post by **riviere** » Tue Jun 01, 2004 4:24 pm

OK it's done. It will be in the next release, and in the next update (if one day we take time to release an update...)
Denis

HughTG · Post by **HughTG** » Wed Jun 02, 2004 9:00 pm

Dennis, thanks

Hugh